WOODWARD 伍德沃德 9907-1183 汽轮机数字调速器

WOODWARD 伍德沃德 9907-1183 汽轮机数字调速器

WOODWARD 伍德沃德 9907-1183 汽轮机数字调速器

1、设置伺服电机的内部转矩限制值;

2、设置值是额定转矩的百分比;

3、任何时候，这个限制都有效定位完成范围;

4、设定位置控制方式下定位完成脉冲范围;

5、本参数提供了位置控制方式下驱动器判断是否完成定位的依据，当位置偏差计数器内的剩余脉冲数小于或等于本参数设定值时，驱动器认为定位已完成，到位开关信号为ON，否则为OFF;

6、在位置控制方式时，输出位置定位完成信号，加减速时间常数;

7、设置值是表示电机从0~2000r/min的加速时间或从2000~Or/min的减速时间;

8、加减速特性是线性的到达速度范围;

9、设置到达速度;

10、在非位置控制方式下，如果电机速度超过本设定值，则速度到达开关信号为ON，否则为OFF;

11、在位置控制方式下，不用此参数;

12、与旋转方向无关。

WOODWARD 伍德沃德 9907-1183 汽轮机数字调速器

1, set the internal torque limit value of the servo motor;

2, the setting value is the percentage of rated torque;

3, at any time, this limitation is effectively positioned to complete the scope;

4, set the position control mode to complete the positioning pulse range;

5. This parameter provides the basis for the driver to judge whether the positioning is complete under the position control mode. When the number of remaining pulses in the position deviation counter is less than or equal to the value set by this parameter, the driver considers that the positioning has been completed, and the switch signal in place is ON, otherwise it is OFF;

6, in the position control mode, the output position positioning complete signal, acceleration and deceleration time constant;

7, the setting value is the acceleration time of the motor from 0 to 2000r/min Or the deceleration time from 2000 to Or/min;

8, acceleration and deceleration characteristics are linear arrival speed range;

9, set the arrival speed;

10, in the non-position control mode, if the motor speed exceeds the set value, the speed to the switch signal is ON, otherwise it is OFF;

11, in the position control mode, do not use this parameter;

12, independent of the direction of rotation.