通用电气 IS215VPROH1BD GE 触点输入组隔离端子板

通用电气 IS215VPROH1BD GE 触点输入组隔离端子板

IS215VCMIH2C 在其面板中内置有四个端口连接。其中包括一个 RS-232C 串行端口、D 型插头连接器和三个 IONet 10Base2 以太网端口。每个 IONet 连接器都与三个标有 TX/RX/CD 的 LED 指示灯相关联。该板具有附加的 LED 指示灯，分别标记为 Status、Fail、Run 和 1、2、4 和 8。者位于复位开关（按钮）上方，而后者位于串行端口的正下方。

IS215VCMIH2C 的宽度为 0.0787 英寸。它采用板载 TI 32 位数字信号处理器芯片设计。该板使用电阻器（超过 400 个）电容器和二管。它具有三个变压器组件。IS215VCMIH2C 有五十多个集成电路，包括振荡芯片。电感磁珠（铁氧体磁珠）有助于抑制电路板上的高频噪声。该板有两个背板连接器、一个 12 针（公）垂直连接器和几个其他导电连接器。

通用电气 IS215VPROH1BD GE 触点输入组隔离端子板

The IS215VCMIH2C has four port connections built into its panel. These include an RS-232C serial port, Type D plug connectors, and three IONet 10Base2 Ethernet ports. Each IONet connector is associated with three LED indicators labeled TX/RX/CD. The board has additional LED indicators labeled Status, Fail, Run, and 1, 2, 4, and 8. It is located above the reset switch (button), which is located directly below the serial port.

The IS215VCMIH2C is 0.0787 inches wide. It uses the on-board TI 32-bit digital signal processor chip design. The board uses resistors (over 400) capacitors and two tubes. It has three transformer components. The IS215VCMIH2C has more than fifty integrated circuits, including oscillating chips. Inductive magnetic beads (ferrite beads) help suppress high-frequency noise on the circuit board. The board has two backplane connectors, a 12-pin (male) vertical connector, and several other conductive connectors.

通用电气 IS215VPROH1BD GE 触点输入组隔离端子板

ABB DCS 3BDH000371R0005 DA 701F数字/模拟模块 ABB RET650

ABB DCS 3BE066485R1 PM 851AK01处理器单元-24MHz和12 MB ABB C310/0020/STD

ABB DCS 3BE069449R1 CI 854BK01 PROFIBUS-DP/V1接口 ABB RET670

ABB DCS 3BSE020512R1 AI 801模拟输入8通道 ABB REF610

ABB DCS 3BSE020514R1 AO 801模拟输出8通道 ABB DSQC633

ABB DCS 3BSE020508R1 DI 801数字输入24V 16通道 ABB F362

ABB DCS 3BSE020510R1 DO 801数字输出24V 16通道 ABB SK616001-A

ABB DCS 3BSE013208R1 TB 820V2 Modulebus群集调制解调器 ABB 3HAC0977-1

ABB DCS 3BSE008508R1 DI 810数字输入模块 ABB S503X