GE DS3800HMPG1C1C  网络控制板 设计用于快速安装在驱动器中

GE DS3800HMPG1C1C  网络控制板 设计用于快速安装在驱动器中

产品描述

GE 网络控制器板DS3800HMPG1C1C设计用于快速安装在驱动器中。该板的一端有一个模块化连接器，另一端有一个固定杆。GE 网络控制器板DS1HMPG3800C1C还装有 1 个红色指示灯 LED 和 2 个琥珀色 LED，从板的前面可见。该板还配备了微处理器、可擦除可编程只读存储器 （EPROM） 模块和 1 引脚连接器。

GE网络控制器板DS3800HMPG1C1C使用EPROM模块来存储微处理器使用的编程指令和固件。您会注意到更换板带有空模块插座。这是因为最佳做法是从旧主板上卸下模块并将其安装在替换板上。由于微处理器的行为必须与原始微处理器相同，因此最好使用相同的编程代码和固件。这样，董事会的行为将相同。这使驱动器能够恢复活动并模拟安装原始主板时体验到的驱动器性能。

操作员可以通过查看指示灯 LED 来监控电路板的运行情况。当驱动器通电并开始运行时，板上的 LED 将全部亮起几秒钟。这使服务人员能够确认 LED 是否正常运行。如果诊断测试的启动序列成功完成，则琥珀色 LED 将亮起，并在驱动器运行时保持亮起。它还指示主板正在通电。如果琥珀色 LED 未亮起，则表示主板未通电。

GE DS3800HMPG1C1C  网络控制板 设计用于快速安装在驱动器中

Product description

The GE Network controller board DS3800HMPG1C1C is designed for quick installation in a drive. The board has a modular connector at one end and a fixed rod at the other end. The GE network controller board DS1HMPG3800C1C also has one red indicator LED and two amber leds visible from the front of the board. The board is also equipped with a microprocessor, erasable programmable read-only memory (EPROM) module, and a 1-pin connector.

The GE network controller board DS3800HMPG1C1C uses an EPROM module to store the programming instructions and firmware used by the microprocessor. You will notice that the replacement board comes with an empty module socket. This is because the best practice is to remove the module from the old motherboard and install it on a replacement board. Since the microprocessor must behave the same as the original microprocessor, it is best to use the same programming code and firmware. In this way, the board will behave the same. This enables the drive to resume activity and simulate the drive performance experienced when the original motherboard was installed.

The operator can monitor the performance of the board by viewing the indicator LED. When the driver is powered up and running, the leds on the board will all light up for a few seconds. This enables the service staff to confirm that the LED is functioning properly. If the startup sequence of the diagnostic test completes successfully, the amber LED will light up and remain lit while the drive is running. It also indicates that the motherboard is being powered on. If the amber LED does not light up, it means that the motherboard is not powered up.