安庆 GE DS3800HMPJ1A1D 工业控制途径

安庆 GE DS3800HMPJ1A1D 工业控制途径

产品描述

DS3800HMPJ1A1D是通用电气Mark IV电路板。该板适合 MKIV 涡轮机控制系统，该系统旨在管理各种尺寸和复杂性的工业燃气轮机和蒸汽轮机。Mark IV是第一个通过使用TMR（三重模块化冗余）布置来提高可靠性的Speedtronic系统。使用重复的处理器对所有输入进行投票可以减少整个系统的停机时间。

该DS3800HMPJ1A1D设计在一个短边上有一个背板连接器，另一个在另一个边缘上有一个电缆连接器，只是我们仓库库存中可用的该板的一个版本。该板标有其 ID 号以及几个代码，以帮助确定位置、接线和其他板规格。代码可能因所售商品而异。

DS3800HMPJ1A1D采用垂直引脚连接器构建。这靠近安装在电路板表面的四个支座，允许添加一个次级子板，该子板将通过电缆连接器与DS3800HMPJ1A1D通信。该板具有 <> 多个集成电路，包括多个 PROM/EPROM。其他电路板组件包括 LED 指示灯（一个黄色、一个红色）、电阻网络阵列、电阻器、二极管、电容器、测试点和跳线开关。跳线用于更改板上的设置;这允许根据最终用户的要求定制电路板。GE 文档将提供有关跳线设置的更多信息。但是，更换板上的跳线通常应与要更换的板上的跳线相匹配。

安庆 GE DS3800HMPJ1A1D 工业控制途径

Product description

The DS3800HMPJ1A1D is a GE Mark IV circuit board. The board fits into the MKIV turbine control system, which is designed to manage industrial gas and steam turbines of all sizes and complexities. The Mark IV is the first Speedtronic system to improve reliability by using a TMR (Triple Modular Redundancy) arrangement. Using duplicate processors to vote on all inputs reduces overall system downtime.

The DS3800HMPJ1A1D design with a backplane connector on one short edge and a cable connector on the other edge is just a version of this board available in our warehouse stock. The board is labeled with its ID number and several codes to help determine location, wiring, and other board specifications. Codes may vary depending on the item sold.

The DS3800HMPJ1A1D is built with a vertical pin connector. This is close to the four supports mounted on the board surface, allowing the addition of a secondary subboard that will communicate with the DS3800HMPJ1A1D via a cable connector. The board has <> multiple integrated circuits, including multiple PROMs/EPROMs. Other board components include LED indicators (one yellow, one red), resistor network arrays, resistors, diodes, capacitors, test points, and jumper switches. Jumpers are used to change the Settings on the board; This allows the board to be customized to the end user's requirements. The GE documentation provides more information about jumper Settings. However, the jumper on the replacement board should usually match the jumper on the board to be replaced.