DS3800HRMB1G1D 发电机调节模块

DS3800HRMB1G1D 发电机调节模块

GE电池ROM板DS3800HRMB1G1D设计用于快速安装在驱动器中。该板的一端有一个模块化连接器，另一端有一个固定杆。该板装有 1 个嵌入在板上的 1 针连接器。GE电池ROM板DS40HRMB3800G1D装有1个复位拨动开关。该板还装有 1 个跳线和 7 个 1 针连接器。模数转换器是嵌入在电路板上的组件。它将模拟信号转换为数字格式。数字格式用于整个驱动器的信号处理。

40 针连接器位于电路板前边缘的固定杆之间。这使操作员可以轻松访问带状电缆。带状电缆源自驱动器中的另一个板或组件，并用塑料连接器端接。连接器将 40 个独立的控制信号传送到电路板。连接器还配有固定闩锁。它们在连接器上摆动并夹入到位以约束连接器。这样可以防止带状电缆意外失去与电路板的联系。要卸下带状电缆，请先在连接器上旋转固定闩锁。然后，对另一个固定闩锁执行相同的操作。

布线布线需要一些特殊考虑。驱动器要求空气在驱动器内自由流动，带状电缆不得阻塞通过驱动器的气流。将电缆从驱动器内部的中心布线，而是沿侧壁布线电缆。

DS3800HRMB1G1D 发电机调节模块

The GE battery ROM board DS3800HRMB1G1D is designed for quick installation in the drive. The board has a modular connector at one end and a fixed rod at the other end. The board is equipped with a 1-pin connector that is embedded in the board. GE battery ROM board DS40HRMB3800G1D is equipped with a reset toggle switch. The board is also equipped with 1 jumper and 7 1-pin connectors. An analog-to-digital converter is a component embedded on a circuit board. It converts analog signals into a digital format. The digital format is used for signal processing throughout the drive.

The 40-pin connector is located between the holding rods on the front edge of the board. This gives the operator easy access to the ribbon cable. The ribbon cable originates from another board or assembly in the driver and is terminated with a plastic connector. The connector transmits 40 separate control signals to the board. The connector is also equipped with a retaining latch. They swing over the connector and clamp into place to restrain the connector. This prevents the ribbon cable from accidentally losing contact with the circuit board. To remove the ribbon cable, rotate the latch on the connector first. Then, do the same for the other fixed latch.

Wiring Wiring requires some special considerations. The driver requires free flow of air in the driver, and the ribbon cable must not block the airflow through the driver. Route the cable from the center inside the drive, instead routing the cable along the side wall.