— 产品中心 —
邮箱:A3669372910@163.com
手机:17359299796
电话:17359299796
地址:福建省漳州市龙文区朝阳北路1号办公楼205室
DS3800HSDD1F1G驱动器 电源模块 输入输出模块品牌GE加工定制否额定功率要求+5 VDC: 1.0 A (USB满载0.5 A时可达1.5 A)工作温度0至60C(32F至140F)执行速度0.072毫秒每1000布尔指令时钟精度每天最大漂移2秒实时时钟电池预计寿命5年嵌入式串行通信Rs-232 (com1) rs-485 (com2)支持的串行协议Modbus RTU Slave,
产品详情
产品描述
DS3800HSDD1F1G是通用电气制造的电路板。DS3800HSDD1F1G成为Speedtronic Mark IV系列的一部分。Mark系列是为控制燃气轮机和蒸汽轮机而开发的。自 1960 年代引入 Mark I 系统以来,涡轮机运营商几十年来一直依靠 Mark 产品来确保涡轮机最高效、最安全的运行。
电路板上具有许多不同的电子元件。插孔连接器端口占据主板左侧的整个长度。另一个较小的连接器端口位于电路板的另一侧。如有必要,可以使用这些连接器将其他组件或其他板连接到DS3800HSDD1F1G。单个中型蓝色电容器放置在较大的连接器端口旁边。
整个电路板上放置了 <> 个不同尺寸的集成电路。每个集成电路芯片上都有非常小的电阻器、电容器和二极管。在电路板的上边缘和下边缘都是带有红色跳线的跳线引脚。分散在电路板周围的是小型黄色电容器和各种颜色的条纹电阻器。七个测试点位于电路板的右边框,标有 RST、DSYNC、COM、SYNC 和 DATA 等名称。三个发光二极管或LED紧挨着测试点,其中两个是红色的,第三个是橙色的。电路板周围还可以找到一些银色二极管。
Product description
The DS3800HSDD1F1G is a circuit board manufactured by General Electric. The DS3800HSDD1F1G is part of the Speedtronic Mark IV series. The Mark series was developed for the control of gas and steam turbines. Since the introduction of the Mark I system in the 1960s, turbine operators have relied on Mark products for decades to ensure the most efficient and safe operation of their turbines.
There are many different electronic components on a circuit board. The jack connector port occupies the entire length of the left side of the motherboard. Another smaller connector port is located on the other side of the board. If necessary, these connectors can be used to connect other components or other boards to the DS3800HSDD1F1G. A single medium-sized blue capacitor is placed next to the larger connector port.
There are <> integrated circuits of different sizes placed on the entire board. Each integrated circuit chip has very small resistors, capacitors, and diodes. On both the top and bottom edges of the board are jumper pins with red jumpers. Scattered around the board are small yellow capacitors and striped resistors of various colors. The seven test points are located on the right border of the board and are labeled with names such as RST, DSYNC, COM, SYNC, and DATA. Three light-emitting diodes, or leds, are next to the test site, two of which are red and the third is orange. Some silver diodes can also be found around the board.
相关推荐