DS3800HSQD1E1B 低HP序列板 每个角上都有一个孔

DS3800HSQD1E1B 低HP序列板 每个角上都有一个孔

GE 低 HP 序列板DS3800HSQD1E1E设计为每个角上都有一个孔，用于插入螺钉以将板固定在驱动器中。GE 低 HP 序列板DS1HSQD3800E1E还配备了 1 个 2 针连接器和 40 个带固定杆的 1 针连接器，用于固定带状电缆。该板还装有 20 针连接器和 50 个 1 针连接器。该板还装有 20 个可擦除可编程只读存储器 （EPROM） 模块和 1 个琥珀色指示灯 LED 和 1 个红色指示灯 LED。

当您收到更换板上的 EPROM 模块时，它是空的。这是标准配置，因为最佳做法是在更换板上使用与原始板上相同的固件和编程代码。只有使用相同的代码，才能确保驱动器在安装更换板时运行相同。可以使用相同的固件和编程代码，因为模块可以从旧板上卸下并安装在替换板中。

模块安装在原始板上的插座中。它牢固地固定在插座中，但可以轻松拆卸。在模块和插座之间的开口中插入一把小平头螺丝刀。提起螺丝刀以弹出模块。在插座的另一端重复此过程。立即将模块放入静态保护袋中，并将其放置在安全位置。

DS3800HSQD1E1B 低HP序列板 每个角上都有一个孔

The GE Low HP sequence board DS3800HSQD1E1E is designed with a hole in each corner for inserting screws to secure the board in the drive. The GE Low HP serial board DS1HSQD3800E1E also comes with 1 2-pin connector and 40 1-pin connectors with fixed rods for securing ribbon cables. The board is also equipped with 20-pin connectors and 50 1-pin connectors. The board is also equipped with 20 erasable programmable read-only memory (EPROM) modules and one amber LED and one red LED.

When you receive the EPROM module on the replacement board, it is empty. This is standard since best practice is to use the same firmware and programming code on the replacement board as on the original board. Only by using the same code can you ensure that the drive runs the same when the replacement board is installed. The same firmware and programming code can be used, as modules can be removed from the old board and installed in a replacement board.

Modules are installed in sockets on the original board. It is securely secured in the socket but can be easily removed. Insert a small flat head screwdriver into the opening between the module and the socket. Lift the screwdriver to eject the module. Repeat the process on the other end of the socket. Immediately place the module in a static protection bag and place it in a safe location.