DS3800HXCA1A1A印刷电路板 该系统是使用集成芯片组创建

DS3800HXCA1A1A印刷电路板 该系统是使用集成芯片组创建

DS3800HXCA1A1A印刷电路板 该系统是使用集成芯片组创建

产品描述

DS3800HXCA1A1A是通用电气制造的印刷电路板。它是其Mark IV / Speedtronic系统中的一个组件，专为燃气和蒸汽轮机控制而设计。该系统是使用集成芯片组创建的，这些芯片组与某些功能重叠，并且在发生电子设备故障时将自动承担损坏板的责任。这使用户有时间修复或更换损坏的电路板，而整个系统几乎没有停机时间。

DS3800HXCA1A1A设计为移位寄存器板，具有以下规格：

它有五个电阻网络。这些可用于分压或将数据从模拟转换为数字。

它有七个跳线开关。其中五个彼此排成一排。J7 单独放置，允许用户在 5.5 mHz 和 11 mHz 之间进行选择。

它有三个测试点。

它在电路板的右上象限有备用电镀通孔。

它是工厂钻孔的。

它具有多个集成电路，包括像摩托罗拉SN74LS20N那样的人字拖，以及像德州仪器的SN4S74N那样的双74针DIP。

它有五个 LED 分成两组。一个短边的下角有三个红色 LED;这些被标记为“本地”，“公共汽车”和“陈”。在同一侧的上角，还有一个标记为“活动”的红色 LED，以及一个标记为“ImOk”的琥珀色 LED。

它有两个母连接器，位于电路板的相对两侧。

DS3800HXCA1A1A印刷电路板 该系统是使用集成芯片组创建

Product description

The DS3800HXCA1A1A is a printed circuit board manufactured by General Electric. It is a component in its Mark IV/Speedtronic system, designed for gas and steam turbine control. The system is created using integrated chipsets that overlap with certain functions and will automatically assume responsibility for damaging the board in the event of an electronic device failure. This gives users time to repair or replace damaged boards with little downtime for the entire system.

The DS3800HXCA1A1A is designed as a shift register board with the following specifications:

It has five resistor networks. These can be used to divide pressure or convert data from analog to digital.

It has seven jumper switches. Five of them lined up with each other. The J7 is placed separately, allowing users to choose between 5.5 mHz and 11 mHz.

It has three test points.

It has spare plating through holes in the upper right quadrant of the board.

It was drilled by the factory.

It features multiple integrated circuits, including flip-flops like the MOTOROLA SN74LS20N, and dual 74-pin DIps like the Texas Instruments SN4S74N.

It has five leds divided into two groups. One short side has three red leds in the lower corner; These are labeled "local," "Bus," and "Chan." On the top corner of the same side, there is also a red LED labeled "Active," and an amber LED labeled "ImOk."

It has two female connectors, located on opposite sides of the board.