DS380ONFOA1C1D GE FANUC点火电路板

DS380ONFOA1C1D GE FANUC点火电路板

DS380ONFOA1C1D GE FANUC点火电路板

GE点火电路板DS3800NF0A1C1D的每个角上有一个孔，用于用螺钉将电路板固定到变频器内部。该板有4个支座，用于连接子卡。子卡提供了额外的处理、连接器和功能。电路板上装有多个晶体管-晶体管逻辑器件。

GE点火电路板DS38OONFOA1C1D也装有13个红色指示灯LED和1个琥珀色指示灯LED。该板还有一个用于电可擦除可编程只读存储器(EEPROM)模块的插座。该板i还配有多个跳线和2个34引|脚连接器。

34针连接器位于电路板的一边，这样带状电结就不会干扰电路板上的元件。也就是说，带状电缆可以远离电路板并沿着驱动器的侧面布线，而不是穿过电路板的表面。34针连接器有固定门锁，防止带状电缆意外断开。

但是，固定门锁需要一些特殊考虑。在将带状电缆连接到车接器之前，必须一次打开一个固定门锁。然后，您可以将带状电缆连接到板上的连接器。要固定带状电缆，请在带状电缆上旋转固定门锁，直到它们卡入到位。

DS380ONFOA1C1D GE FANUC点火电路板

The GE ignition circuit board DS3800NF0A1C1D has a hole in each corner for fastening the circuit board to the inside of the inverter with screws. The board has four supports for connecting subcards. The daughter card provides additional processing, connectors, and functionality. Multiple transistor-transistor logic devices are installed on the circuit board.

The GE ignition circuit board DS38OONFOA1C1D also has 13 red indicator leds and 1 amber indicator LED. The board also has a socket for an electrically erasable programmable read-only memory (EEPROM) module. The board i is also equipped with multiple jumpers and 2 34-lead | pin connectors.

The 34-pin connector is located on one side of the board so that the ribbon junction does not interfere with the components on the board. That is, the ribbon cable can be run away from the board and along the side of the driver, rather than across the surface of the board. The 34-pin connector has a fixed door lock to prevent accidental disconnection of the ribbon cable.

However, fixed door locks require some special considerations. A fixed door lock must be opened one at a time before the ribbon cable is connected to the car adapter. You can then connect the ribbon cable to the connector on the board. To secure the ribbon cable, rotate the lock on the ribbon cable until they snap into place.