GE DS3800NFCD1S1K 驱动模块

GE DS3800NFCD1S1K 驱动模块

GE DS3800NFCD1S1K 驱动模块

产品描述

通用电气制造了DS3800NFCD1S1K点火电路板，作为Mark IV（Speedtronic）系列的组件。该系列由GE开发，作为燃气轮机和蒸汽轮机管理系统。它还可以自动执行涡轮机系统的停机、启动和冷却程序。

DS3800NFCD1S1K是一个较大的印刷电路板，充当较小DS3800DFCD的主板。连接后，该辅助板可访问三个电流表和四个跳线。它在每个角落由尼龙销支撑，并用 <> 个板对板连接器销固定到位。

DS3800NFCD1S1K在每个角落都经过工厂钻孔。它有五个额外的钻孔点：每个左角一个，板体三个。DS3800NFCD1S1K由两个 Augat DIP 插头、一个 5 针垂直连接器和位于其右边缘的另外两个连接器组成。该板有二十多个晶体管、三十个测试点和两个插水开关。

GE DS3800NFCD1S1K 驱动模块

Product description

Ge manufactures the DS3800NFCD1S1K ignition circuit board as a component of the Mark IV (Speedtronic) series. The series was developed by GE as a gas turbine and steam turbine management system. It also automatically performs shutdown, start-up and cooling procedures for turbine systems.

The DS3800NFCD1S1K is a larger printed circuit board that acts as a motherboard for the smaller DS3800DFCD. When connected, the auxiliary board has access to three ammeters and four jumpers. It is supported at each corner by nylon pins and held in place with <> board-to-board connector pins.

The DS3800NFCD1S1K is drilled through the factory at every corner. It has five additional drill points: one in each left corner and three in the plate body. The DS3800NFCD1S1K consists of two Augat DIP plugs, a 5-pin vertical connector, and two more connectors located on its right edge. The board has more than twenty transistors, thirty test points and two water plug switches.