DS3800NFOA1C1D General Electric 冗余控制单元

DS3800NFOA1C1D General Electric 冗余控制单元

DS3800NFOA1C1D General Electric 冗余控制单元

DS3800NGDC设计具有以下规格:

·它有三个水泥绕线电阻器。其中两个使用尼龙插头将电线抬离电路板。

·它有两个(蓝色)25V 10opuf电容器和两个黄色Seacor聚酯直流箔和薄膜轴向引线电容器(600v)。板上还有多个其他电容器。

·它在各个角落都经过工厂钻孔。

它有一个边缘沿线的备用PTH(电镀通孔)。

它有三个晶体管填充电路板，包括一个较大的摩托罗拉晶体管。·它有四个集成电路。

它有六个测试点。但是，它们编号为TPO到TP5。TPO是一个接地点。·它有一个沿一个边缘的三引脚接头(公头)。

它有一个五位PC安装端了条，位于一个边缘，一个2位PCB接线端子位于另一边缘。

·它有两个咬接式PCB安装座(螺钉安装座)。

它具有各种电阻器和电容器填充电路板。

DS3800NFOA1C1D General Electric 冗余控制单元

The DS3800NGDC is designed with the following specifications:

· It has three cement winding resistors. Two of them use nylon plugs to lift the wires off the board.

It has two (blue)25V 10opuf capacitors and two yellow Seacor polyester DC foil and film axial lead capacitors (600v). There are multiple other capacitors on the board.

· It is drilled through the factory at all corners.

It has an edge along the spare PTH(electroplated through hole).

It has three transistor-filled boards, including a larger MOTOROLA transistor. · It has four integrated circuits.

It has six test points. However, they are numbered TPO to TP5. TPO is a ground point. · It has a three-pin joint (male head) along one edge.

It has a five-bit PC mounting end strip located on one edge and a 2-bit PCB terminal located on the other edge.

· It has two bite type PCB mounting seats (screw mounting seats).

It has various resistors and capacitors filled with circuit boards.