531X121PCRAHG1 GE 可编程序控制器

531X121PCRAHG1 GE 可编程序控制器

531X121PCRAHG1 GE 可编程序控制器

产品描述

GE电源连接板531X121PCRAHG1是多个原始设备电源连接板的更新部件。 维修更换电路板的驱动器需要了解使用电气设备的知识。首先要做的是检查该区域是否存在电气安全隐患。确保地板没有潮湿或潮湿，并确保缺失的安全场地也得到修复。并将所有未接地的电源线（2 脚）更换为接地（3 脚）延长线。一些看似与电击绝缘的工具并不是只使用经批准的绝缘手动工具。

您可能计划使用牙科镜来查看难以看到的组件。如果这样做，反射表面是导电的，如果接触带电电流，可能会对服务人员造成伤害或损坏组件。使用高压设备时，最佳做法是使用伙伴系统。也就是说，不要独自工作，并始终有人在附近。在开始之前，请检查所有手动工具、测试设备和其他设备是否有绝缘材料的磨损迹象。丢弃任何磨损绝缘层的工具，以防止发生事故。

将 531X121PCRAHG1 板放在静态保护袋中，直到准备好安装为止。找到平坦干净的表面，握住板的边缘，将保护袋压平在表面上，然后将板放在袋子上。用手指将跳线移到引脚上。

531X121PCRAHG1 GE 可编程序控制器

Product description

The GE power connector 531X121PCRAHG1 is an updated part of several original device power connectors. Repairing and replacing circuit board drivers requires knowledge of the use of electrical equipment. The first thing to do is to check the area for electrical safety hazards. Make sure the floor is not wet or damp, and make sure missing safe areas are also repaired. Replace all ungrounded power cables (pin 2) with grounded (pin 3) extension cables. Some tools that appear to be insulated from electric shock do not use only approved insulated hand tools.

You may plan to use a dental mirror to view hard-to-see components. If this is done, the reflective surface is conductive and may cause injury to service personnel or damage the component if exposed to a live current. When using high voltage equipment, the best practice is to use a buddy system. That is, don't work alone and always have someone nearby. Before you begin, check all hand tools, test equipment, and other equipment for signs of insulation wear. Discard any tools that wear the insulation to prevent accidents.

Place the 531X121PCRAHG1 board in a static protective bag until it is ready for installation. Find a flat, clean surface, hold the edge of the board, flatten the protective bag against the surface, and then place the board on the bag. Move the jumper onto the pin with your fingers.