531X121PCRAGG3 GE 电源连接卡

531X121PCRAGG3 GE 电源连接卡

531X121PCRAGG3 GE 电源连接卡

产品描述

GE电源连接板531X121PCRAGG3是多个原始设备电源连接板的更新部件。 驱动器上的控制面板对于访问诊断信息和关闭驱动器非常有用。键盘上有一个用于停止电机的键，您可以按下它开始有序关闭程序。您可能需要咨询熟悉您现场的电工或工程师，以找到为驱动器供电的电源。找到电源后，取下保险丝以禁用它并停止三相电流。

在触摸任何东西之前，请给驱动器几秒钟的时间以释放组件上的所有残余电量。打开板柜的门，松开固定电源连接板的卡舌。从电路板上取下所有电缆并写上标签以贴在电缆上，以便您知道在哪里重新安装电缆。所有连接器都有编号，可提供用于重新连接的精确标识符。

带状电缆需要更高程度的保养。带状电缆由多根承载信号的小线组成，电线很容易断裂或断开。仅使用带状电缆末端的连接器断开或连接电缆。抓住连接器并将其从主板上的连接器中拉出。要连接它，请将带状电缆固定在连接器上，然后将其压入板上的连接器中。切勿拉扯带状电缆以断开其连接。

531X121PCRAGG3 GE 电源连接卡

Product description

The GE power connector 531X121PCRAGG3 is an updated part of multiple original device power connectors. The control panel on the drive is useful for accessing diagnostic information and shutting down the drive. There is a key on the keyboard for stopping the motor, which you can press to start the orderly shutdown procedure. You may need to consult an electrician or engineer familiar with your site to find the power source to power the drive. After finding the power supply, remove the fuse to disable it and stop the three-phase current.

Before touching anything, give the drive a few seconds to release all the residual power on the component. Open the cabinet door and release the latch holding the power connection board. Remove all cables from the circuit board and write labels to attach to the cables so that you know where to reinstall the cables. All connectors are numbered to provide a precise identifier for reconnection.

Ribbon cables require a higher degree of maintenance. The ribbon cable consists of a number of small wires carrying signals, and the wires are easily broken or disconnected. Disconnect or connect the cable using only the connector at the end of the ribbon cable. Grab the connector and pull it out of the connector on the motherboard. To connect it, attach the ribbon cable to the connector and press it into the connector on the board. Do not pull the ribbon cable to disconnect it.