531X111PSHAKG1 具有用于电机磁场电路的脉冲变压器

531X111PSHAKG1 具有用于电机磁场电路的脉冲变压器

531X111PSHAKG1 具有用于电机磁场电路的脉冲变压器

产品描述

GE 端子板继电器卡 531X111PSHAKG1 提供驱动器使用的 5 V 直流、15 V 直流和 24 V 直流电流。它还具有用于电机磁场电路的脉冲变压器。当您更换GE终端板继电器卡531X111PSHAKG1时，该过程可能包括额外更换3TB灌封MOV组件。在开始更换之前，您必须注意几个注意事项。

3TB 包含多根带状电缆，您必须断开与原始 3TB 的连接。由于构成带状电缆的细线，带状电缆容易断裂。通过握住带状电缆将带状电缆从连接器中拉出会导致电缆损坏并断开细线。卸下带状电缆的最佳做法是用一只手抓住带状电缆上的连接器。用另一只手抓住 3TB 上的连接器，然后从 3TB 上拉出带状电缆。

下一步是卸下固定 3TB 的五个安装螺钉。手头有一把螺丝刀来执行此操作。

考虑到您必须在 3TB 安装表面上钻孔，这可能会导致钻屑和其他碎屑倒在 3TB 或驱动器的其他组件中。必须小心检查驱动器和 3TB 组件是否有松动的碎屑。碎屑可能会导致触电或粘住驱动器的运动部件。

531X111PSHAKG1 具有用于电机磁场电路的脉冲变压器

Product description

GE terminal board relay card 531X111PSHAKG1 provides 5 V DC, 15 V DC, and 24 V DC currents for driver use. It also has a pulse transformer for the motor's magnetic field circuit. When you replace the GE terminal board relay card 531X111PSHAKG1, the process may include the replacement of an additional 3TB pot-seal MOV component. There are several considerations you must be aware of before starting the replacement.

The 3TB contains multiple ribbon cables that you must disconnect from the original 3TB. Because of the thin wires that make up the ribbon cable, it is easy to break. Pulling the ribbon cable out of the connector by holding it will cause damage to the cable and break the thin wire. The best practice for removing a ribbon cable is to hold the connector on the ribbon cable with one hand. Grab the connector on the 3TB with your other hand and pull out the ribbon cable from the 3TB.

The next step is to remove the five mounting screws securing the 3TB. Have a screwdriver on hand to do this.

Considering that you have to drill into the 3TB mounting surface, this can cause drilling chips and other debris to pour into the other components of the 3TB or drive. The drive and 3TB components must be carefully checked for loose debris. Debris can cause an electric shock or stick to moving parts of the drive.