531X111PSHAJG3 端子板继电器卡

531X111PSHAJG3 端子板继电器卡

531X111PSHAJG3 端子板继电器卡

产品描述

GE 端子板继电器卡 531X111PSHAJG3 提供驱动器使用的 5 V 直流、15 V 直流和 24 V 直流电流。它还具有用于电机磁场电路的脉冲变压器。GE 终端板继电器卡 531X111PSHAJG3 具有 3TB 灌封 MOV 组件，您可以在更换板的过程中进行更换。首先更换GE端子板继电器卡531X111PSHAJG3，然后更换3TB灌封MOV组件。

3TB 程序集包含一条带状电缆，您必须将其从原始程序集移动到新组件。将一只手放在带状电缆的连接器上，另一只手放在板上的连接器上。拉开接头。如果用电缆握住带状电缆将其拉开，则可能会发生损坏。

五个安装螺钉将组件固定到安装表面上。使用螺丝刀卸下五个螺钉并将它们放在一边以备将来使用。同时拆下位于安装表面上的四个支撑柱。您可以使用短螺丝刀执行此过程。

标记四个孔以放置组件，并使用钻头制作孔。必须小心确保钻孔产生的碎屑不会落在 3TB 或驱动器的其他组件上。完成该过程后，使用真空清洁金属屑、灰尘和钻屑的所有表面和组件。当您为驱动器通电时，碎屑可能会损坏组件。

531X111PSHAJG3 端子板继电器卡

Product description

GE terminal board relay card 531X111PSHAJG3 provides 5 V DC, 15 V DC, and 24 V DC currents for the driver. It also has a pulse transformer for the motor's magnetic field circuit. GE Terminal board Relay Card 531X111PSHAJG3 features a 3TB pot-seal MOV component that you can replace during board replacement. First replace the GE terminal board relay card 531X111PSHAJG3, then replace the 3TB pot-seal MOV assembly.

The 3TB assembly contains a ribbon cable that you must move from the original assembly to the new component. Place one hand on the connector of the ribbon cable and the other hand on the connector on the board. Pull the joint. Damage may occur if the ribbon cable is pulled apart by holding it with the cable.

Five mounting screws secure the assembly to the mounting surface. Use a screwdriver to remove five screws and set them aside for future use. Also remove the four support columns located on the mounting surface. You can perform this process using a short screwdriver.

Mark four holes to place the assembly and use a drill to make the holes. Care must be taken to ensure that debris from drilling does not fall on the 3TB or other components of the drive. After the process is complete, vacuum clean all surfaces and components of metal chips, dust and drill chips. When you power the drive, debris can damage the component.