DS200IQXSG1AAA 驱动控制电路板卡GE

DS200IQXSG1AAA 驱动控制电路板卡GE

DS200IQXSG1AAA 驱动控制电路板卡GE

GE逆变器缓冲板DS200IQXSG1AAA还包含一个8引脚连接器和一个安装在板上的薄膜电容器。该板是安装在板柜中的多块板之一。尺寸为6.25乘5英寸，四个角上的孔与板架上的安装孔对齐。如果没有新的螺丝，请使用固定旧主板的螺丝。

由于硬盘中的电路板和移动部件会产生热量，因此安装硬盘时，冷却是一个重要的考虑因素。驱动器必须有一个可以自由流过驱动器的清洁空气源，以将组件保持在允许的温度范围内。驱动器的设计使得冷而干净的空气从底部进入驱动器，并通过驱动器内部上升。它绕过组件，将热量从硬盘中带走。

另一个考虑因素是，驱动器不要靠近其他产生热量的设备，并且驱动器周围的墙壁不会被墙壁另一侧的设备加热。

如果驱动器变得过热并超过温度范围，则会检测到超温情况，驱动器将自动停止。该安全特征将防止部件损坏。它还能防止火灾的发展。

DS200IQXSG1AAA 驱动控制电路板卡GE

The GE inverter buffer board DS200IQXSG1AAA also contains an 8-pin connector and a thin-film capacitor mounted on the board. The board is one of several boards installed in the board cabinet. The dimensions are 6.25 by 5 inches, and the holes in the four corners are aligned with the mounting holes in the plate frame. If new screws are not available, use the screws that held the old motherboard in place.

Because the circuit boards and moving parts in a hard drive generate heat, cooling is an important consideration when installing a hard drive. The drive must have a clean air source that can flow freely through the drive to keep the components within the permitted temperature range. The drive is designed so that cold, clean air enters the drive from the bottom and rises through the inside of the drive. It bypasses the components and takes the heat away from the hard drive.

Another consideration is that the drive is not near other devices that generate heat, and that the walls around the drive are not heated by devices on the other side of the wall.

If the drive becomes overheated and exceeds the temperature range, an overtemperature condition will be detected and the drive will automatically stop. This safety feature will prevent part damage. It also prevents the development of fires.