GE 电机保护装置SR469-P5-HI-A20-E CPU模块 DCS备件

GE 电机保护装置SR469-P5-HI-A20-E CPU模块 DCS备件

GE 电机保护装置SR469-P5-HI-A20-E CPU模块 DCS备件

SR469-P5-HI-A20-E DOS实用程序FDISK通常用于配置硬盘驱动器。其他实用程序可用于执行此任务。隔断PowerQuest的Magic是一款受欢迎且功能强大的商用程序。下面的注释与使用FDISK进行分区有关。

IS215ACLEH1A闪存盘将配置为从工厂以下示例序列说明了创建两个分区，其中一个作为活动主分区。记下退出说明FDISK。这已被证明是成功分区的重要一步气力接通VMIVME-7698电源，然后进入CMOS设置。

将主主机设置为无。将辅助主机设置为自动。将引导设备设置为松软的从软盘引导DOS；在启动屏幕上验证烧瓶盘是否显示为闪存0。运行FDISK。删除所有当前分区（当前存储在分区中的任何数据都将被删除丢失）。

HIEE300024R4 UAA326A04退出FDISK，这将导致重新启动，然后再次运行FDISK。创建主分区。创建扩展分区并为其设置逻辑设备。11.运行FDISK/MBR。

Run FORMAT C：（如果您希望将闪存作为可引导磁盘，请使用/s选项DOS设备。）格式D：（仅当创建了两个分区时才需要）。重置CPU并进入CMOS设置。将主控形状设置为“自动”将引导设备设置为所需的引导源。

GE 电机保护装置SR469-P5-HI-A20-E CPU模块 DCS备件

SR469-P5-HI-A20-E DOS utility FDISK is commonly used to configure hard drives. Other utilities can be used to perform this task. Partition PowerQuest's Magic is a popular and powerful business program. The following comments relate to partitioning using FDISK.

The IS215ACLEH1A flash drive will be configured from the factory The following example sequence illustrates the creation of two partitions, one of which serves as the active primary partition. Write down the exit instructions FDISK. This has proven to be an important step in successful partitioning by turning on the VMIVME-7698 power and then entering the CMOS setup.

Set the primary host to none. Set the secondary host to automatic. Set the boot device to floppy boot DOS; Verify that the flask disk appears as Flash 0 on the startup screen. Run FDISK. Delete all current partitions (any data currently stored in the partition will be deleted and lost).

HIEE300024R4 UAA326A04 Exits FDISK, which will cause a restart and then run FDISK again. Example Create a primary partition. Create an extended partition and set up logical devices for it. 11. Run the FDISK/MBR command.

Run FORMAT C: (If you want the flash as a bootable disk, use the /s option DOS device.) Format D: (required only if two partitions are created). Reset the CPU and go to CMOS Settings. Set the master shape to Automatic. Set the boot device to the desired boot source.