GE EPSCPE100-ABAC 美国通用紧凑型高性能模块

GE EPSCPE100-ABAC 美国通用紧凑型高性能模块

GE EPSCPE100-ABAC 美国通用紧凑型高性能模块

EPSCPE100-ABAC：如果该卡以前没有成功地向站点发送消息，那么它将不会重试消息。令牌错误限制vmeTokErrLimit是256个令牌周期中的最大错误数。允许的值为0到255，默认值为255。如果vme选项中的OPTION_STAY_OFF_ERR位是1，则卡将脱机，您必须重新加载卡，然后将其重新在线。

如果此位为0，则该卡将增加相应的错误计数器并脱机，然后立即返回联机。响应错误限制响应错误限制vmeRespErr限制是16条连续消息中消息失败的最大次数（例如，超过重试限制）。允许的值是1到15，默认值是15。

EPSCPE100-ABAC:如果vme选项中的OPTION_STAY_OFF_ERR位是1，则卡将脱机，您必须重新加载卡，然后将其重新在线。如果OPTION_STAY_OFF_ERR位为0，则该卡增加相应的错误计数器并脱机，然后立即返回联机。

1.确保卡脱机。 2.如第3.6.2节，总线参数中所述，为各种网络参数编写适当的值。在大多数情况下，不要更改由卡分配的默认值。 3.发出命令CMD_CHK_NET_CFG或CMD_GO_ONLINE，等待7秒。

GE EPSCPE100-ABAC 美国通用紧凑型高性能模块

EPSCPE100-ABAC: If the card has not previously successfully sent a message to the site, it will not retry the message. Token error limit vmeTokErrLimit is the maximum number of errors in 256 token cycles. The allowed values range from 0 to 255, and the default value is 255. If the OPTION_STAY_OFF_ERR bit in the vme option is 1, the card will go offline and you will have to reload the card and then bring it back online.

If this bit is 0, the card will increase the corresponding error counter and go offline, then immediately return online. Response Error Limit Response Error Limit The vmeRespErr limit is the maximum number of times a message can fail in 16 consecutive messages (for example, exceeding the retry limit). The allowed values are 1 to 15, and the default value is 15.

EPSCPE100-ABAC: If the OPTION_STAY_OFF_ERR bit in the vme option is 1, the card will go offline and you must reload the card and then bring it back online. If the OPTION_STAY_OFF_ERR bit is 0, the card increases the corresponding error counter and goes offline, then immediately goes back online.

1. Make sure the card is offline. 2. Write the appropriate values for the various network parameters, as described in Section 3.6.2, Bus Parameters. In most cases, do not change the default values assigned by the card. 3. Run the CMD_CHK_NET_CFG or CMD_GO_ONLINE command and wait 7 seconds.