EMERSON艾默生 CE4050S2K1C0控制模块 PLC/DCS备件

EMERSON艾默生 CE4050S2K1C0控制模块 PLC/DCS备件

EMERSON艾默生 CE4050S2K1C0控制模块 PLC/DCS备件

I/O点数估算时应考虑适当的余量，通常根据统计的输入输出点数，再增加10%~20%的可扩展余量后，作为输入输出点数估算数据。实际订货时，还需根据制造厂商可编程逻辑控制器的产品特点，对输入输出点数进行圆整。

存储器容量是可编程序控制器本身能提供的硬件存储单元大小，程序容量是存储器中用户应用项目使用的存储单元的大小，因此程序容量小于存储器容量。设计阶段，由于用户应用程序还未编制

因此，程序容量在设计阶段是未知的，需在程序调试之后才知道。为了设计选型时能对程序容量有一定估算，通常采用存储器容量的估算来替代。

I/O point estimation should consider the appropriate margin, usually according to the statistical input and output points, and then increase the expandable margin of 10% to 20%, as the input and output point estimation data. When actually ordering, it is also necessary to round out the input and output points according to the product characteristics of the manufacturer's programmable logic controller.

The memory capacity is the size of the hardware storage unit that can be provided by the programmable controller itself, and the program capacity is the size of the storage unit used by the user application project in the memory, so the program capacity is less than the memory capacity. Design phase, because the user application has not yet been written

Therefore, the program capacity is not known during the design phase and is not known until the program is debugged. In order to have a certain estimation of program capacity during the design and selection, the estimation of memory capacity is usually used instead.