51305896-200 NIM MODEM HONEYWELL 调节板 controller EPNI

51305896-200 NIM MODEM HONEYWELL 调节板 controller EPNI

每一个NDIO模块都将取代ACS 600标准I/O板上（NIOC）的某些标准输入信号，取决于模块的地址（1至3）。每一个NDIO模块的继电器输出都增加了传动系统继电器输出信号的数量。

继电器输出信号所代表的信息是预先编程的，用户不能改变。用户应检查并调整下列参数，以便激活NDIO模块。在调整参数前，应检查模块的地址设置是否正确。注意，新参数设置只有在模块下次上电时才能生效。

Each NDIO module will replace certain standard input signals on the ACS 600 Standard I/O Board (NIOC), depending on the module's address (1 to 3). The relay output of each NDIO module increases the number of transmission relay output signals.

The information represented by the relay output signal is pre-programmed and cannot be changed by the user. The user should check and adjust the following parameters to activate the NDIO module. Before adjusting the parameters, check that the address of the module is set correctly. Note that the new parameter Settings take effect only when the module is powered on the next time.

PR6423/000-030十C0N021  
PR6424/010-120十C0N021   
PR6423/011-010十C0N021
PR6423/012-130+C0N021  
PR6423/00R-010+C0N021   
PR6423/03R-010+CON021 
PR6423/13R-010+C0N021   
PR6424/002-031
PR6423/016-030十C0N021  
PR6423/010-130十C0N021 
PR6423/015-010十CONO21   
PR6423/11R-131+C0N031 
PR9268/301-100 
PR9268/302-100 
PR9376/010-011  
A6120  
A6410