HONEYWELL CC-PCF901 模块驱动系统 支持 40 冗余模件

HONEYWELL CC-PCF901 模块驱动系统 支持 40 冗余模件

C300控制器模块

·运行 CEE (控制操作系统)支持 PMIO

-C系列 1/0

-A系列卡件式 1/0

·灵活的 1/0 支持:

- 可混合使用不同的 1/0 接口支持2个IOLINK 接口

-每个C300 最多支持 64个冗余 1/0 模件

每个 1OL 可以支持 40 冗余模件 

但是，如果需要使用VME64机箱，VME64背板将使用：160引脚5行连接器，其中只有背板引脚的中心三行用于信号、电源和接地。因此VMIVME-7455在VME64机箱中，必须小心确保正确的对齐使用第9页图4所示的64芯电缆组件，以：通过将CPU板连接到CD ROM和可选的VMIVME-7452背板。两种电缆应使用相同的64芯电缆组件VMEbus和VME64背板。接口电缆零件号为VMIC型号编号：VMIVME-VMXC-3。本节提供了与VMIC的保养和维护相关的信息产品。如果产品出现故障，请验证以下内容：软件系统配置电气连接跳线或配置选项电路板完全插入其正确的连接器位置连接器引脚清洁且无污染插入或移除时，相邻板的任何组件均不会受到干扰将板从机箱中卸下电缆和I/O连接的质量如果必须退货，请联系VMIC获得退货材料授权（RMA）编号。此RMA编号必须在任何退货前获得。

HONEYWELL CC-PCF901 模块驱动系统 支持 40 冗余模件

C300 controller module

· Run CEE (Control Operating System) to support PMIO

-C Series 1/0

-A series card type is 1/0

· Flexible 1/0 support:

- Different 1/0 interfaces can be mixed. Two IOLINK interfaces are supported

- Each C300 supports up to 64 redundant 1/0 modules

Each 1OL can support 40 redundant modules

However, if a VME64 chassis is required, the VME64 backplane will use: 160 pin 5-row connectors, where only the center three rows of the backplane pins are used for signal, power, and ground. Therefore VMIVME-7455 In the VME64 chassis, care must be taken to ensure proper alignment using the 64-core cable assembly shown in Figure 4 on page 9 to: by connecting the CPU board to the CD ROM and the optional VMIVME-7452 backplane. Both cables should use the same 64-core cable assembly VMEbus and VME64 backplane. The part number of the interface cable is VMIC model number: VMIVME-VMXC-3. This section provides information products related to the care and maintenance of VMIC. If the product fails, verify the following: Software System Configuration Electrical connection jumper or Configuration options Circuit boards are fully inserted into their correct connector positions Connector pins are clean and pollution-free None of the components of the adjacent boards are disturbed when inserted or removed Remove the board from the case The quality of the cable and I/O connections If you must return a product, contact VMIC for a Returned Material Authorization (RMA) number. This RMA number must be obtained before any return.