DM-20 PLC模块

DM-20 PLC模块

DM-20 PLC模块

(一)工作条件

1、电源电压交流220 (v)2、工作电流9安(A)

3、工作频率50~60赫兹(Hz)4、功率2.0KVA

(二)工作模式及

1、温度控制模式，设定测量范围0～240°C。

2、时间控制模式，设定测量范围0~99分59秒。

3、温度保持:按下温度保持键，当加热工件达到设定温度后，进入温度保持状态。

4、本产品在工作时具有软启动的功能，减小了启动时对器件的冲击，延长使用寿命;断电时采用软停机方式，实现自动去掉工件剩磁的功能。

(三)数码显示及声频提示

1、温度设定，该加热装置预置温度值为110℃.

2、时间设定可在99分59秒内任意设定。

3、在每个加热周期末有声频信号提示。

4、传感器非正常工作时，该装置有声频信号提示。

DM-20 PLC模块

1) Working conditions

1, power supply voltage AC 220 (v)2, working current 9 A (A)

3, working frequency 50~60 Hz (Hz)4, power 2.0KVA

(b) Working mode and

1, temperature control mode, set measuring range 0 ~ 240°C.

2, time control mode, set measuring range 0~99 minutes 59 seconds.

3, temperature hold: press the temperature hold key, when the heating workpiece reaches the set temperature, enter the temperature hold state.

4. The product has the function of soft start when working, which reduces the impact on the device when starting and prolongs the service life; When the power is off, the soft stop mode is used to realize the function of automatically removing the residual magnetic of the workpiece.

(3) Digital display and audio prompt

1. Temperature setting, the preset temperature of the heating device is 110℃.

2, the time setting can be arbitrarily set within 99 minutes and 59 seconds.

3, at the end of each heating cycle there is an audio signal prompt.

4, when the sensor is not working properly, the device has an audio signal prompt.