LAM 810-046015-010 可编程控制器模块

LAM 810-046015-010 可编程控制器模块

LAM 810-046015-010 可编程控制器模块

810-046015-010当此标题出现在显示器中时，按向下箭头键进行配置此块或按左或右箭头键选择另一个要配置的块。每个功能键选项只能配置一次。此外，函数必须对功能键使用的功能进行编程，否则将出现错误消息。

例如，要使用级联控制启用功能键，“使用级联”必须对功能进行编程。F3键执行（必须从列表中选择）使用向上/向下调整箭头或通过滚动选项列表选择“否”键，直到出现所需选项，然后按“是”或输入选项/功能。

功能键F3和F4的选项（未使用）远程Extr/Adm Setpt启用本地/远程选择Extr/Adm优先级空闲/额定Casc控制启用停止/继续自动启动序列远程Casc Setpt启用远程速度设置启用辅助控制启用同步启用远程辅助设置启用频率防护/解除防护激励继电器输出Extr/Adm控制启用F3 LED未激活时闪烁？dflt=否（是/否）选择YES（是），然后选择ENTER（回车），以在以下情况下闪烁功能键的LED：功能未激活，但已启用。

无论何时功能处于活动状态。如果否，则当功能启动时，功能键LED点亮已启用、活动或状态。F4键执行（必须从列表中选择）使用向上/向下调整箭头或通过滚动选项列表选择“否”键，直到出现所需选项，然后按“是”或输入键以选择选项/功能。

LAM 810-046015-010 可编程控制器模块

810-046015-010 When this title appears on the display, press the down arrow key to configure this block or press the left or right arrow keys to select another block to configure. Each function key option can be configured only once. In addition, the function must be programmed for the function used by the function key, otherwise an error message will appear.

For example, to enable function keys with Cascade control, Use Cascade must program the function. F3 key execution (must be selected from the list) Use the up/down adjustment arrow or select the "No" key by scrolling through the list of options until the desired option appears, then press "Yes" or enter the option/function.

Function keys F3 and F4 Options (not used) Remote Extr/Adm Setpt Enable Local/remote Select Extr/Adm priority Idle/Rated Casc Control Enable Stop/Continue automatic start sequence Remote Casc Setpt Enable remote speed Settings Enable secondary control Enable synchronization Enable Remote secondary Settings Enable frequency guard/Deguard excitation relay Output Extr/Adm control Enable F3 LED blink when not activated? dflt= No (YES/No) Select YES (Yes) and then ENTER (Enter) to flash the LED of the function key in the following case: The function is not activated, but is enabled.

Whenever the function is active. If not, the function key LED lights up enabled, active, or status when the function is started. F4 Key Execution (must be selected from the list) Use the up/down adjustment arrow or select the "No" key by scrolling through the list of options until the desired option appears, then press "Yes" or enter the key to select the option/function.