CTI模块 2500-RBC 901E-2500-RBC

CTI模块 2500-RBC 901E-2500-RBC

CTI模块 2500-RBC 901E-2500-RBC

• 在装配和调试之前，请详细阅读产品说明书。不正确地使用本产品可能会导致人身伤害 或设备损坏。务必严格遵守安装说明和要求。

• 各系统组件必须接地。通过低阻抗的接地来 电气安全(根据 EN/IEC 618005-1 标准， 保护等级 1)。电机应通过独立的接地导体连接至保护地，其接地导体的规格不可低于电 机动力电缆的规格。本产品内有对静电敏感的元件，不正确的放置会损坏这些元件，请 避免本产品接触到高绝缘材料 (如人造纤维、 塑料薄膜等等)，应将其置于导电表面。操 作人员通过触碰接地的无漆金属表面释放一切可能产生的静电。

• 操作期间，请勿打开外壳及电气柜柜门。否则，潜在的危险可能导致人身伤害或设备损 坏。

• 操作期间，本产品内含充电元件和高温器件。散热片温度可以达到 90°C。即使电机没 有旋转，控制电缆和电源电缆仍会带有高压。

CTI模块 2500-RBC 901E-2500-RBC

• Read the product instructions carefully before assembly and commissioning. Improper use of this product may result in personal injury or equipment damage. Be sure to strictly follow the installation instructions and requirements.

• All system components must be grounded. Electrical safety by grounding with low impedance (protection level 1 according to EN/IEC 618005-1). The motor shall be connected to the protective ground through an independent ground conductor, the specification of the ground conductor shall not be lower than the specification of the motor power cable. This product contains electrostatic sensitive components, incorrect placement will damage these components, please avoid the product contact with high insulation materials (such as artificial fibers, plastic film, etc.), should be placed on the conductive surface. The operator releases any possible static electricity by touching a grounded, unpainted metal surface.

• Do not open the housing and electrical cabinet doors during operation. Otherwise, potential hazards may result in personal injury or equipment damage.

• During operation, this product contains charging elements and high temperature devices. The heat sink temperature can reach 90°C. Even if the motor is not rotating, the control cable and the power cable will still carry high voltage.