贝加莱5AP1130.156C-000 15.6英寸多点触控显示屏

贝加莱5AP1130.156C-000 15.6英寸多点触控显示屏

B&R 5AP1130.156C-000触控面板LED的含义也印在前面模块的面板。对其他每个通道重复此操作按下并释放测试按钮的时间。在最后一个通道E/A7（输入/输出7）扫描，再次按下测试按钮会导致指示灯亮起要执行的测试（LED测试）。

所有8个LED都应亮起向上的松开按钮后，LED将显示插入式底座上DIL开关的设置约5秒。LED 0显示开关的位置1号（LED 0…7分配给1…8号交换机）。所有错误消息都存储在模块中，可以只能通过按下测试按钮10秒删除或通过电源关闭/打开。

A4.5中错误消息的确认远程模块远程模块存储并显示错误独立于中央单元检测到的消息。这个可以确认错误消息通过按下测试按钮在远程模块上通过功能块在用户程序中CS31QU（这也会删除存储的错误消息在中央单元中）通过命令在终端模式下邮件，见第7.3卷第3章。如果错误尚未消除，错误消息再次出现错误：到具有模块的远程模块的总线地址3在操作期间被中断。中央单元中的错误标志07 KR 91/07 KT 92/07 KT93：假设错误标志已被设置为0在错误发生之前确认/删除。在里面下面，只列出那些错误标志内容发生变化。

The meaning of the B&R 5AP1130.156C-000 touch panel LED is also printed on the front module panel. Repeat the time to press and release the test button for each other channel. In the last channel E/A7 (input/output 7) scan, pressing the test button again will cause the indicator to light up for the test to be performed (LED test).

All 8 leds should light up after the upward release button, and the LED will display the setting of the DIL switch on the plug-in base for about 5 seconds. LED 0 shows switch position 1 (LED 0... 7 is assigned to 1... Switch number 8). All error messages are stored in the module and can be deleted only by pressing the test button for 10 seconds or by power off/on.

Confirmation of error messages in A4.5 Remote Module The remote module stores and displays messages in which errors are detected independently of the central unit. This can confirm the error message by pressing the test button on the remote module through the function block in the user program CS31QU (which will also delete the stored error message in the central unit) through the command in terminal mode mail, see volume 7.3 Chapter 3. If the error has not been eliminated, the error message again shows an error: the bus address to the remote module with the module 3 was interrupted during the operation. Error flag 07 KR 91/07 KT 92/07 KT93 in the central unit: Assume the error flag has been set to 0 to confirm/remove before the error occurs. Below the inside, list only those errors that indicate that the content has changed.