CTC SC203-100A-002IR-010-01K-05 温度信号调节器

CTC SC203-100A-002IR-010-01K-05 温度信号调节器

CTC SC203-100A-002IR-010-01K-05具有板载闪存大容量存储系统，允许主机发出命令，在闪存中读取或写入内存块内存阵列。VMIVME-7698该闪存盘在用户看来是一个智能ATA（IDE）磁盘具有与“旋转介质”IDE硬盘相同的功能和能力的驱动器驾驶闪存作为辅助IDE总线主设备驻留在VMIVME-7698上（辅助IDE总线从设备不可分配）。默认设置为自动。这可以在BIOS菜单中看到。

从BIOS主菜单中选择Secondary掌握并按下返回键。默认类型为自动。参考附录C、 Phoenix BIOS了解更多详细信息。图4-6描绘了由以下部件组成的典型系统的配置可能性：VMIVME-7698，带有驻留闪存，硬盘连接到主IDE接口，3BHE046836R0102 GFD563A102以及连接到软盘接口的软盘驱动器。

主要和次要PCI IDE接口在中控制（启用或禁用）Phoenix BIOS的高级屏幕。引导顺序由启动菜单中堆栈的顺序。图4-6标识了分配给每个物理设备的驱动器号，并在在每个配置中使用以下设备引导的设备的粗体字母：可引导。术语可引导是指操作系统已在其上启动的设备已安装或已使用MS-DOS格式化为系统磁盘。

CTC SC203-100A-002IR-010-01K-05 has an onboard flash memory mass storage system that allows the host to issue commands to read or write memory blocks to memory arrays in flash memory. VMIVME-7698 This flash drive appears to the user as a smart ATA (IDE) disk with the same functions and capabilities as a "rotating media" IDE hard drive drive flash resides on the VMIVME-7698 as a secondary IDE bus master device (secondary IDE bus slave device is not assignable). The default setting is automatic. You can see this in the BIOS menu.

Select Secondary from the BIOS main menu and press the Back key. The default type is automatic. Refer to Appendix C, Phoenix BIOS for more details. Figure 4-6 depicts the configuration possibilities of a typical system consisting of the following components: VMIVME-7698, with resident flash, hard disk connected to the main IDE interface, 3BHE046836R0102 GFD563A102, and a floppy disk drive connected to the floppy disk interface.

The primary and secondary PCI IDE interfaces control (enable or disable) the advanced screen of the Phoenix BIOS. Boot order is the order of the stacks in the boot menu. Figure 4-6 identifies the drive letter assigned to each physical device and uses the bold letters of the devices that boot in each configuration with the following: Bootable. The term bootable means that a device on which the operating system has started has been installed or formatted as a system disk using MS-DOS.