METSO美卓I/O处理器 IOP341 原厂供应 SAC自动化备件

METSO美卓I/O处理器 IOP341 原厂供应 SAC自动化备件

METSO IOP341装置配置不正确或装置错误。检查断路器是否有故障信息。如果没有故障信息，则更换CI858单元。输入/输出；Rx1 LED亮起（未亮起闪光）该单元未接收数据。检查所有电缆和连接。如果没有故障信息，则更换CI858单元。输入/输出；Rx1 LED熄灭，无信号发送至装置或装置错误。

检查所有电缆和连接。更换CI858装置。输入/输出；Tx1 LED亮起（不亮闪光）该单元不传输数据。检查断路器是否有故障信息。如果CB中没有故障信息更换CI858单元。

输入/输出；Tx1 LED熄灭，装置未正确配置或装置错误。检查断路器是否有故障信息。如果没有故障信息，则更换CI858单元。CI860板正在安装中重新启动或配置。留出时间，以便：最后确定。如果该情况持续存在，并且没有其他单元指示灯亮起CEX总线点亮：检查有效的硬件配置，包括：CI860被下载到控制器。检查日志文件检查CPU单元内的CEX总线保险丝。从CPU启动复位信号（INIT）单元更换CI860装置。F（故障）指示灯亮起。检查所有电缆和接头是否损坏和损坏连接松动或不良。

METSO IOP341 The device configuration is incorrect or the device is incorrect. Check whether the circuit breaker has fault information. If no fault information exists, replace the CI858 unit. Input/output; Rx1 LED on (not on flash) The unit does not receive data. Check all cables and connections. If no fault information exists, replace the CI858 unit. Input/output; Rx1 LED off, no signal sent to the device or device error.

Check all cables and connections. Replace the CI858. Input/output; Tx1 LED on (off flashing) The unit does not transmit data. Check whether the circuit breaker has fault information. If no fault information exists in CB, replace CI858.

Input/output; The Tx1 LED is off, the device is incorrectly configured or the device is incorrect. Check whether the circuit breaker has fault information. If no fault information exists, replace the CI858 unit. The CI860 is being restarted or configured during installation. Set aside time to: finalize. If the condition persists and no other unit indicator lights up, the CEX bus lights up: Check the valid hardware configuration, including: The CI860 is downloaded to the controller. Check log files Check the CEX bus fuse in the CPU unit. The CPU start reset signal (INIT) unit replaces the CI860 device. The F (fault) indicator is on. Inspect all cables and joints for damage and loose or poor connections.