UCD208A101 3BHE020018R0101 高压变频调节板卡

UCD208A101 3BHE020018R0101 高压变频调节板卡

UCD208A101 3BHE020018R0101 高压变频调节板卡

UCD208A101 3BHE020018R0101控制板卡假设新主机所有单元均已卸载当一个单元的优先级发生变化，使其成为新的主单元时在系统上，系统对主机更改的响应取决于系统的操作状态。

如果系统未加载且发动机未运行遇到或未配置为电源丢失情况，然后切换主机的优先级将对系统产生以下影响：最多5秒后，主指示处于排序状态屏幕将指示新的主单元。发生这种情况后不久，新的主设备的排序状态屏幕将重新排序下一个打开和下一个关闭从属设备，以适应新的系统优先级配置由于新主人的任命。

假设加载了新的主控形状下一个排序优先级更改场景涉及主单元打开由于失去电源条件，隔离母线。这两个从属单元已离线因为系统负载不要求它们在线排序。更改主机的网络优先级将在系统

UCD208A101 3BHE020018R0101 高压变频调节板卡

UCD208A101 3BHE020018R0101 Control Board Assuming that all units of the new host have been uninstalled When the priority of a unit changes, making it the new master unit on the system, the system's response to the host change depends on the operating state of the system.

If the system is not loaded and the engine is not running or is not configured for a power loss situation, then switching the priority of the host will have the following effect on the system: After a maximum of 5 seconds, the main indicator is in the sorted state the screen will indicate the new main unit. Shortly after this happens, the sorting status screen of the new master device will reorder the next open and next closed slave devices to accommodate the new system priority configuration due to the appointment of the new master.

Assuming a new master shape is loaded, the next sort priority change scenario involves the master unit turning on due to a loss of power condition, isolating the bus. The two slave cells are offline because the system load does not require them to be sorted online. Changing the host's network priority will be in the system