1394-AM04 AB美国模块

1394-AM04 AB美国模块

1394-AM04 AB美国模块

1394-AM04 是Allen-Bradley ControlLogix控制器，属于ControlLogix 555系列。尽管该控制器没有非易失性存储器，但它确实具有5KB的数据和逻辑存储器以及15KB的I / O存储器。1756-L1M1轻便，重约12.5盎司或.35千克。用户可以将控制器安装在可用的机箱插槽中。

另外，这款大的Allen-Bradley控制器具有开放式外壳等。该模块配有可换电池。但是，其电池只能用称为1756-BA1的.59 g电池换。此外，1756-L1M1与3类额定值的1756-CP3串行电缆兼容。1756-L1M1具有5至95的非冷凝相对湿度范围，并且其工作温度约为至6摄氏度。

1756-L1M1的背板温度在5.1伏时为95mA，在24伏时为2mA。本机的额定功率为5.33瓦，平均功耗为4.6瓦。此外，1756-LIMI的平均散热量估计为15.6 BTU /小时。1756-L1M1的振动在1到5赫兹之间，峰值加速度为2.G。此外，本机的工作冲击在11毫秒内3G峰值。将1756-L1M1的电压为3伏时，应将其冲击等在不5G的环境下存储11毫秒。同样，如果工业应用对所使用的电压有严格要求，则该Allen-Bradley模块已经过测试，可在6秒内舒适地承受5伏的电压。1756-L1M1具有6 kV的ESD接触放电扰度。加，它具有8 kV的ESD空气放电扰性。这使其成为工业需求的的模块之一。

1394-AM04 AB美国模块

The 1394-AM04 is an Allen-Bradley ControlLogix controller belonging to the ControlLogix 555 series. Although the controller does not have non-volatile memory, it does have 5KB of data and logic memory and 15KB of I/O memory. The 1756-L1M1 is lightweight and weighs approximately 12.5 ounces or.35 kg. Users can install the controller in the available chassis slots.

In addition, this large Allen-Bradley controller has an open housing and more. The module is equipped with a replaceable battery. However, its battery can only be replaced with a.59 g battery called 1756-BA1. In addition, the 1756-L1M1 is compatible with Class 3 rated 1756-CP3 serial cables. The 1756-L1M1 has a non-condensing relative humidity range of 5 to 95, and its operating temperature is about 6 degrees Celsius.

The backplane temperature of the 1756-L1M1 is 95mA at 5.1 volts and 2mA at 24 volts. The unit has a rated power of 5.33 watts and an average power consumption of 4.6 watts. In addition, the average heat dissipation of 1756-LIMI is estimated to be 15.6 BTU/hour. The 1756-L1M1 vibrates between 1 and 5 Hz with a peak acceleration of 2.G. In addition, the unit's operating impact peaks at 3G within 11 milliseconds. When the voltage of the 1756-L1M1 is 3 volts, it should be stored in a non-5G environment for 11 milliseconds. Similarly, if industrial applications have strict requirements for the voltage used, this Allen-Bradley module has been tested to comfortably withstand a voltage of 5 volts in 6 seconds. The 1756-L1M1 has ESD contact discharge interference of 6 kV. Plus, it has 8 kV ESD air discharge interference. This makes it one of the modules required by industry.