A-B罗克韦尔1785-ME64/A供应系列PLC系统控制器应用模块

A-B罗克韦尔1785-ME64/A供应系列PLC系统控制器应用模块

1785-ME64在10至500赫兹时的振动为2克，而在11毫秒时的运行和非运行冲击分别为30克和50克。

要安装Allen-Bradley 1785-ME64 EEPROM模块，请将电源切换至输入/输出机箱并卸下处理器。另外，确保背板开关6和7应根据产品手册进行设置，以避免任何数据丢失或错误。

保持键控销向下，将1785-ME64内存模块插入处理器。用力推内存模块，以听到咔哒声，确认连接器引脚已卡入处理器的连接器中。安全地将处理器插入输入/输出机箱。

传输和执行程序后，切换电源并重复处理器的卸下过程。从处理器上撬出1785-ME64内存模块，并使用尖嘴钳拆下其写保护跳线。重复上述过程以重新安装内存模块和处理器。

The 1785-ME64 vibrates 2 grams at 10 to 500 Hertz, while the operating and non-operating shocks at 11 milliseconds are 30 grams and 50 grams, respectively.

To install the Allen-Bradley 1785-ME64 EEPROM module, switch the power to the input/output case and remove the processor. Also, ensure that backplane switches 6 and 7 should be set according to the product manual to avoid any data loss or error.

With the keying pin down, insert the 1785-ME64 memory module into the processor. Push hard on the memory module to hear a clicking sound and confirm that the connector pins are stuck in the processor connector. Safely insert the processor into the input/output enclosure.

After transferring and executing the program, the power supply is switched and the process of removing the processor is repeated. Pry the 1785-ME64 memory module from the processor and remove its write protection jumper using needle-nose pliers. Repeat the process to reinstall the memory module and processor.