BENTLY 3500/40M 176449-01胀差轴向位置模块

3500/40M Proximitor Monitor的主要用途是提供以下资料:通过连续比较进行机械保护根据配置告警监控参数设置驱动告警操作和操作的基本机器信息维修人员每个通道，通常取决于配置调节其输入信号以产生各种参数称为静态值。您可以配置的警报设定值每个活动静态值和危险设定值为任意两个活动静态值。

3500/40M模块要求如下(或固件和软件修订:软件版本- 2.503500/02软件版本- 2.203500/03软件-版本1.21当订购/O模块与外部终止外部终止块电缆必须分别订购| / 0模块。不能使用外部终止块内置终端/O模块。

总线外部终止块是仅用于TMR I/O模块。内部屏障I/O模块参考3500内部屏障规范表(文件141495)如果内部屏障选中“选项"

BENTLY 3500/40M 176449-01胀差轴向位置模块

The main purpose of the 3500/40M Proximitor Monitor is to provide the following data: Mechanical protection by continuous comparison according to the configuration alarm monitoring parameters set the basic machine information that drives the alarm operation and operation Maintenance personnel each channel, usually depending on the configuration adjusts its input signal to produce various parameters called static values. You can configure the alarm setpoint for each activity static value and the danger setpoint to any two activity static values.

The requirements for the 3500/40M module are as follows (or firmware and software revisions: Software version - 2.503500/02 Software version - 2.203500/03 Software - Version 1.21 When ordering /O modules and external termination External termination block cables must be ordered separately for | /0 modules. Internal terminal /O modules cannot be used with external termination blocks.

The bus external termination block is used only for TMR I/O modules. Internal barrier I/O module Refer to 3500 Internal Barrier Specification Table (file 141495) If internal barrier is selected "Options"